HOW IT WORKS...
1. ORDER
Place your order online
2. SHIP
Ship your ECM along with a copy of your order to:
DDMWorks
ATTN: TUNE
207 Johnson Street
Pickens SC 29671
*see additional notes below
3. INSTALL
We will return your ECM loaded with the new Performance tune
to you so all you have to do is re-install your ECM and move on to step 3
4. ENJOY YOUR RIDE!
Check engine light, Code P0606, may appear upon first start up after your vehicle has been re-flashed.
Do not be alarmed. After 3-4 drive cycles (drive cycle being more than 20 miles) this code will reset automatically.
If code does persist after 3-4 full drive cycles, please contact us.
*Please note: Ship your ECM and a copy of your order to DDMWorks.
ECM Shipping to DDMWorks is the full responsibility of the customer.
We recommend shipping your ECM with signature required and insurance value of $600.00
You will be charged for return shipping at time of order.
ECM’s are flashed on a first come first served basis, depending on workload, flashes may take
2-3 days business days plus shipping time. Please keep this in mind when shipping your ECM.
As always, if you have any questions, do not hesitate to contact us!
After your tune is installed...
If you make any major modifications to your vehicle after tuning, an updated tune may be required.
If you make changes, contact us so we can discuss the best tuning options for your setup.
In some cases, you may see a check engine light after installation.
If that happens, please check the trouble codes and email them to us at
[email protected] so we can review them for you.
Most check engine lights (if one appears at all) will automatically clear after 3 complete drive cycles.
A drive cycle is defined as the engine going from completely cold, to full operating temperature, and then cooling back down again.
Also, if your vehicle has a Pedal Commander or PedalMax installed,
we recommend removing it, as those devices can sometimes cause issues with the tune.
Thanks again for choosing DDMWorks!