Ecotec Oil Filter Adapter by DDMWorks
DDMWorks billet oil filter adapter for all Ecotec engines (2.0L LSJ and LNF, 2.2L L61, 2.4L LE5 and LE9). Our adapter fits in place of the factory oil filter cap filter in the engine block and comes tapped for two -10AN o-ring fittings. The filter adapter is machined from 6061 T6 aluminum and then black anodiazed for protection and a clean look installed. Our filter adapter is able to be used on the Ecotec engines with the integrated oil cooler without removal of the cooler for installation also. We use this adapter as part of our oil cooler kits on the Solstice/Sky and Slingshot, but it can be used to make your own installation also.
- Aluminum hard black anodized for protection
- Fits: 2.0L, 2.2L and 2.4L Ecotec engines
- Adapter only.
- Adapter accepts -10AN o-ring fittings.
- WARNING:This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov.
Worked perfectly for my Ariel Atom
Worked perfectly for a remote oil filter setup on my Ariel Atom 2 (Ecotec LSJ). Especially with the Harrop TVS supercharger installed the oil filter is extremely difficult to access on the Atom, so this was a major serviceability upgrade. Would have been nice if the outlet/inlet ports were labeled, but not difficult to figure out. Unlike the CBM Ectotec oil filter adaptor, this part does not interfere with the factory oil cooler which was a game changer for my application. Highly recommended!
Reviewed by: Dave from SHERWOOD.
on 1/11/2021
Reward Points
40 points will be rewarded to you when you buy this item.