DDMWorks Cold Air Intake for Jackson Racing Superchargers for Miata 1994-1997
The Jackson Racing supercharger is a great way to add some power to your miata, and makes it drive like it should have come from the factory. However, the supercharger intake is not the best design. The Originalintake pulls hot air close to your exhaust header, up to 30 degrees hotter than ambient, decreasing the air available for the supercharger and lowering the power the supercharger can make. Our intake encloses a new foam pod filter inside a stainless steel enclosure that gets fed plenty of cool air from behind the drivers side headlight. This drops your intake temps up to 30 degrees and pressurizes the intake tract leading to the supercharger, helping to maximize the power your supercharger can make. An extra benefit to our filter assembly is that it takes only a few seconds to remove the pod filter for routine cleaning. Give your supercharged Miata the intake it should have come with.
If your miata is equipped with cruise control, you will need to relocate the cruise control actuator. Check out our relocation kit >> Cruise Control Relocation Kit
- Fits: 1994-1997 Miata with Jackson Racing Supercharger
- Fully enclosed
- Drops intake temps up to 30 degrees
- Maximizes power to supercharger
- 304 stainless steel
- Stainless steel hardware
- UNI foam filter, factory pre-oiled
- WARNING:This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov.
This product has not been submitted for California CARB approval. Off-road use only in California and states adopting California emission standards.
56 points will be rewarded to you when you buy this item.