1.4L Ecotec Throttle Body Spacer by DDMWorks
A perfect little throttle body spacer with two 1/8" NPT tapped holes that can be used for a boost gauge hookup or water/meth spray.
Made from 3/4" CNC machined Aluminum and then finished with a long lasting black anodize finish, this piece installs between the stock throttle body and intake manifold. The 1/8" NPT holes can be used to add a barb fitting to run to a boost gauge, most aftermarket water/meth kits also use a 1/8" NPT fitting that will work in the spacer also. Plugs and a 3/16" barb fitting are also provided if you are planning on hooking up a boost gauge.
Made from 3/4" CNC machined Aluminum and then finished with a long lasting black anodize finish, this piece installs between the stock throttle body and intake manifold. The 1/8" NPT holes can be used to add a barb fitting to run to a boost gauge, most aftermarket water/meth kits also use a 1/8" NPT fitting that will work in the spacer also. Plugs and a 3/16" barb fitting are also provided if you are planning on hooking up a boost gauge.
*** Fits 1.4L Ecotec Turbo Engine only - Engine code LUV
- Made from 3/4" CNC machined Aluminum, black anodized finish
- 1/8" NPT tapped holes, Qty 2
- Comes with 2 Plugs and 1 - 3/16" barb fitting
- Fits 1.4L Ecotec Turbo Engine only - Engine code LUV
- WARNING:This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov.
This product has not been submitted for California CARB approval. Off-road use only in California and states adopting California emission standards.
Reward Points
14 points will be rewarded to you when you buy this item.